Description

Ultra Shield Boss SB-GLP Gloss Look For Concrete

Ultra Shield Boss SB-GLP Gloss Look For Concrete is a penetrating solvent-based sealer designed for stamped concrete and concrete. Application of Ultra Shield Boss SB-GLP will enhance the color and give a gloss appearance with adding ultra protection.
A matte version is available. Once treated, the surface repels water and oil to prevent staining.

FEATURES

Stain & Oil Resistant

Water Resistant

Enhances & Preserves Natural Color

Available in Standard MATTE and GLOSS

PREPARATION
Clean dirt, wax, grease, oil, and other contaminants from the surface. Be sure to remove any foreign coating unless
previous coating is same or similar solvent based sealer or stain. Make sure the surface is clean, dry, and sound. Clean
oily concrete with a CLEANER DEGREASER NEUTRALIZER or other degreasing soap. Use a bristle brush for
heavily oiled spots. If surface is not adequately porous, etch and CLEAN. Rinse well with a pressure
washer. Allow 24 hours to dry. Apply only when surface and air temperatures are above 50° F and below 90° F. For
pavers, sweep away any loose sand.

APPLICATION
Brush may be used where roller or sprayer won’t reach. Do not pour directly from can to concrete. Apply evenly from
can or other metal container with appropriate roller. If rolling, use a solvent resistant nap roller. Cross-roll the second
coat perpendicular to the first coat. Do not allow to puddle. If spraying, use an acetone resistant pump sprayer and clean
up immediately with aromatic solvent or Xylene. Do not thin product. Foot traffic should be avoided
for 4 hours. Vehicle traffic should be avoided for 48 hours. Cooler temperatures or increased humidity will slow the dry.

NET COVERAGE RATE
Two thin coats are recommended. Over application may result in a slick surface.
Textured or Stamped: 200 ft² per gallon
Exposed Aggregate: 100 ft² per gallon
Concrete Pavers: 75 ft² per gallon

TROUBLESHOOTING
If surface becomes slick or blisters due to over application, soak the surface with A1 Solvent or Xylene and roll.

CLEANUP
Clean tools with A1 Solvent, Xylene or Acetone.

MAINTENANCE
Clean sealed surface with water and detergents as needed. Re-seal surface no more often than every two years or as
needed to prevent buildup of sealer.