Description

Ultra Seal Boss SBC-25 Professional Clear Gloss Finish

Ultra Seal Boss SBC-25 is our Original Formula Professional Grade pure acrylic, solvent-based sealer that adds a long-lasting gloss to cured concrete. Excellent for all types of decorative concrete. With a 25% solids content and gloss finish, this hard working sealer will get the job done,  Residential. Light Commercial, Driveways, Walkways, Patios. Remenber Gloss is Boss!

Ultra Seal Boss SBC-25 is a tough pure acrylic concrete sealer in a solvent base. It is designed to protect and beautify all types of concrete with a high gloss durable clear coating. Also available in MATTE finish. Ultra Seal Boss SBC-25 is non-yellowing to preserve the appearance of all types of decorative concrete.

Ultra Seal Boss SBC-25/30 is formulated as follows:

FEDERAL <700 VOC Compliant: available in 30% and 25%.
<600 VOC Comliant: Available in 19% solids.

Ultra Seal Boss SBC-25 VX (LOW <400 VOC Compliant) is a low acetone slow drying formula for easy application; available in 25% solids.
Ultra Seal Boss SBC-25 VT is a no acetone slower drying formula for easier application; available in 25% and 19% solids.
Ultra Seal Boss SBC-25 VZ is a no acetone and the slowest drying formula for the easiest application; available in 22% solids.
Ultra Seal Boss SBC-25 VS  (ULTRA LOW <100 VOC Compliant)  is a low acetone slow drying application formula; available in 23% solids.
Ultra Seal Boss SBC-25 VC is special formulated to be compliant in all California Air Districts; available in 23% solids.

PREPARATION
Clean dirt, wax, grease, oil and other contaminants from the surface. Be sure to remove any foreign coating unless previous coating is same or similar solvent-based sealer. Make sure the surface is clean, dry and sound. Clean oily concrete with a CLEANER DEGREASER
NEUTRALIZER.

Use a bristle brush for heavily oiled spots. If surface is slick, etch and Rinse well with a pressure
washer. Allow 24 hours to dry. Apply only when surface and air temperatures are above 50° F and below 90° F. Do not apply to excessively
hot surfaces as rapid drying may cause bubbles to form. For pavers, sweep away any loose sand. DO NOT THIN.

APPLICATION
Brush may be used where roller won’t reach. Do not pour directly from can to concrete. Apply evenly from can or other metal container with appropriate roller. Use a long nap roller for exposed aggregate, a medium nap roller for textured surfaces and a short nap roller for smooth surfaces. Wait until the surface is tack-free before applying a second coat. Apply perpendicular to the first coat. Cross-rolling allows for an even application. If spraying, use a solvent resistant sprayer holding tip no more than 8” from surface during application. Back rolling is recommended while spraying. Clean up immediately with SOLVENT, Xylene or Acetone. Foot traffic should be avoided for 4 hours. Vehicle traffic should be avoided for 48 hours. Cooler temperatures or increased humidity will slow the dry time.

NET COVERAGE RATE
Two thin coats are recommended for net coverage of:
Smooth Troweled: 300 ft² per gallon Textured or Stamped: 200 ft² per gallon
Broom Swept: 200 ft² per gallon Exposed Aggregate and Pavers: 100 ft² per gallon