Description

 Aqua Boss CS- Eco WB-15 Satin Wet Look Finish is a cross linking, styrene-acrylic copolymer solution formulated to achieve both a protective and decorative finish as well as allow the concrete to attain full mix design properties and is a film-forming sealer, which will also assist the curing of freshly placed concrete.

Aqua Boss CS- Eco WB-15 Satin is formulated as follows:

Aqua Boss CS- Eco WB-15 Satin is a high solids water based curing and seal that meets ASTM C309 A and B and ASTM C1315
This sealer is an economical low viscosity, low solids formula for easy sprayability that meets ASTM C309 A

BENEFITS
Satin Finish
Low V.O.C.
Sprayable
Non-yellowing

PREPARATION
Clean dirt, wax, grease, oil and other contaminants from the surface. Be sure to remove any foreign coating unless previous coating is same or similar water-based sealer. Make sure the surface is clean, dry and sound. Clean oily concrete with a CLEANER DEGREASER. Use a bristle brush for heavily oiled spots. If surface is slick, etch with an ETCHER & CLEANER. Rinse well with a pressure washer. Allow 24 hours to dry. Apply only when surface and air temperatures are above 50° F and below 90° F. Do not apply to excessively hot surfaces as rapid drying may cause bubbles or streaking to form.

APPLICATION
Apply at substrate temperatures above 50° F. Apply with sprayer. If applying to fresh concrete, wait until all bleed water has evaporated. For exterior
concrete, you may use a medium nap roller. For smooth concrete you may use a short nap roller and cross roll. Thoroughly saturate surface. Apply
additional coats as needed. Foot traffic should be avoided for 4 hours. Vehicle traffic should be avoided for 48-72 hours. Cooler temperatures or
increased humidity will slow the dry.

NET COVERAGE RATE
Two thin coats are recommended.
Smooth Troweled: 300 ft² per gallon
Textured or Stamped: 200 ft² per gallon
Broom Swept: 200 ft² per gallon