Description

 Aqua Boss Pro WB-25 UA Gloss Finish is high solids (25%), urethane modified acrylic sealer formulated to achieve both a protective and decorative finish, resist hot tire pickup, and resist abrasion. Aqua Boss Pro WB-25 UA Gloss Finish is a film-forming sealer, which is nonflammable and environmentally friendly.

FEATURES
Gloss Finish
Low V.O.C
High Solids
U.V. Resistant

PREPARATION
Clean dirt, wax, grease, oil and other contaminants from the surface. Be sure to remove any foreign coating unless previous coating is same or similar water-based sealer. Make sure the surface is clean, dry and sound. Clean oily concrete with a CLEANER DEGREASER.
Use a bristle brush for heavily oiled spots. If surface is slick, etch with a ETCHER & CLEANER. Rinse well with a pressure washer. Allow 24 hours to dry. Apply only when surface and air temperatures are above 50° F and below 90° F. Do not apply to excessively hot surfaces as rapid drying may cause bubbles or streaking to form. For pavers, sweep away any loose sand.

APPLICATION
Apply at substrate temperatures above 50° F. Apply with sprayer. For exterior concrete, you may use a medium nap roller. For smooth concrete you may use a lamb’s wool applicator or short nap roller and cross roll. Thoroughly saturate surface. Apply additional coats as needed for increased gloss. Foot traffic should be avoided for 4 hours. Vehicle traffic should be avoided for 48-72 hours. Cooler temperatures or increased humidity will slow the dry.

NET COVERAGE RATE
Two thin coats are recommended.
Smooth Troweled: 300 ft² per gallon Textured or Stamped: 200 ft² per gallon
Uncured Broom Swept: 200 ft² per gallon Exposed Aggregate and Pavers: 100 ft² per gallon